Plumbing is at the root of many insurance claims involving water damage. A frequent check of various components of your plumbing system could spare you the stress and trouble of a costly water damage claim, some of which may not be covered by your insurance policy. To avoid water damage, perform the following five plumbing inspections. Check Pittsburgh Appliance Repair.
1. Look for evidence of leakage surrounding your toilet. The wax seal is the most typical site for toilets to leak and cause water damage. This is a circular wax seal that connects the toilet to the flange below. The toilet may begin to wobble and break the wax seal if the bolts that hold it straight down become loose or worn. A brown or yellow stain on the ceiling beneath the toilet often indicates a faulty wax seal. Feel around the backend of the toilet as well, because a bad tank to bowl gasket or bolts can cause a leak down the back of the toilet, which is frequently misdiagnosed as a wax seal leak. Last but not least, ensure that the fill tube within the toilet tank is cut below the level of the tank handle to help prevent water damage. You want the water to drain down the fill tube before flowing out through the tank lever opening if the fill-valve breaks and the water does not shut off.
2. Another plumbing area that is well-known for causing water damage is the tub/shower system. Examine the caulking around the tub spout and handle escutcheons in addition to the visible sections around the curtain or door. If the caulking is damaged, remove it with a putty knife, clean it, and dry it before replacing it with new bathroom caulking. Inspect the overflow gasket behind the overflow if you have an access panel behind the tub. Two screws are normally used to hold it in place. These gaskets will dry rot and will need to be replaced. This is a bigger issue if the tub is used for baths rather than showers.
3. Look carefully under all sinks, paying special attention to the point where the trap meets the wall. Because the water leaks in below the sink cabinet and into the area below, this spot can go undetected. Always keep an eye out for the dishwasher drain hose when working under the kitchen sink. It is frequently connected to its own p-trap and will be at a lower level than your sink basin, making it the first place water will overflow if your sink is slow or clogged. Last but not least, look under the sink for all valves and supply lines, and make sure to splash some water all over the faucet deck to ensure a good connection to the sink basin.
4. Check your property’s main shut-off valve. Regardless of whether any of the other valves in your home are operational, make sure this one is. You want this valve to be able to swiftly and effectively shut off the water to the house if there is a major leak inside.
5. A broken washing machine hose can cause a lot of water damage in a short period of time since they frequently fail catastrophically rather than gently leaking. If there are any bubbles on the hose, replace it right away. Because they are stronger and endure longer, the new stainless steel braided kind should be used. It’s also a good idea to switch to ball valves for the valves to which the hoses are connected. When the valves are not in use, you can easily close them.