Replacing a damaged fence post may seem to be a challenging process, but it is not as difficult as it seems. It does need some elbow grease and a few basic equipment that you most likely already have in your shed or workshop. So, where do you begin? You must first evaluate the project and the damage. Was the post rotted and simply broke, or was it sheered off due to bad weather? Is there a stump left, or has it been cut off at the field or concrete level? Don’t worry; the job is mildly difficult and should only take you 1 to 2 hours to finish, during which your fence would be as nice as new. Get more info about Fence Repair-Minneapolis Fence pros.
Level of Difficulty: Moderate
Approximately 1 to 2 hours of time is needed. Tools that are needed
1 Replacement – Shovel – Pry Bar – Level 1 – 80 pound bag of Quickrete Concrete Mix – Usually 4″ x 4″ x 8′ Cedar or Treated Lumber
+ 3 “Screws for wood (Approximately 12 Screws)
- Clam or Auger Shelled out Gravel Bag for Post Hole Digger
- Circular Saw or Hand Saw
Most fence posts are set into the ground with concrete, but others are set into the ground with packed soil in the fence post hole. If you don’t see concrete at ground level, reach down a few inches around the fallen post with an ordinary shovel and see if you can find it. Most fence posts are set in concrete, and a typical post hole is roughly eight (8″) to twelve (12″) inches in diameter, with the majority being twenty-four (24″) inches in diameter “) inches in depth
When it comes to deleting an old message, there are few schools of thinking. Some people use the smash and grab method, which involves breaking the concrete into tiny fragments with a hammer and chisel or pry bar and pulling them out of the current hole one by one. The method works, but it takes a long time to clear the concrete from the crater, which can take anything from one to two hours. If you just have one post to replace, it’s great, but if you have plenty, the job is boring and exhausting, and there are better options.